Crocodile Wall Joint Mortar

Adhesive mortar for lightweight wall system

  • Can be used for installation lightweight wall panel.
  • Good adhesion, enhance strength on the lightweight wall panel.
  • Low shrinkage, reduce the cracking problem.

Color : Grey powder
Packing : 20 kg/bag

Store Finder JORAKAY CORPORATION map

Information

Crocodile Wall Joint Mortar Adhesive mortar for lightweight wall system. It provides good adhesion, enhance strength on the lightweight wall panel. Low shrinkage, reduce the cracking problem at the joint area between sheet. Can be used for filling small holes and fissures. It designed for installation of EPS-Cement wall panel, light weight aggregate concrete wall panel, light weight concrete wall panel and etc.

How to use

Substrate Preparation

  • The substrate must be cleaned. Free from loose particle. Dirt, dust, any oils, other impurities or foreign materials must be removed.
  • In case the installation of light weight aggregate concrete wall panel, light weight concrete wall panel and any high-water absorption material. Recommend to damp onto the side of panel before apply adhesive mortar, to reduce water absorption of material cause cracking problem.
  • In case the EPS-Cement wall panel. Recommend to apply Thinner AAA onto the side of panel before apply adhesive mortar, to enhance the bonding properties.


Mixing Ratio
Water : Crocodile Wall Joint Mortar = 1 : 2.5-3.0 by volume
or water 4 liter per Crocodile Wall Joint Mortar 1 bag (20 kg)

Mixing Method

  • Mix Crocodile Wall Joint Mortar with water. Stir with slow speed electric mixer (< 150 rpm) till homogeneous.
  • Leave for cure 15 minutes and stir second time. Do not add more water / Crocodile Wall Joint Mortar after allow curing.


Application Method

  • Adhesive for panel to structure.
    Damp the surface by water. Laying by place a layer of Crocodile Wall Joint Mortar by trowel along the footing or ceiling. Apply 5-7 mm of Crocodile Wall Joint Mortar by trowel onto the side end of the panel. Place the panel gently in line with the laying of Crocodile Wall Joint Mortar. Remove excess by trowel.
  • Adhesive for panel and panel.
    Apply 5-7 mm of Crocodile Wall Joint Mortar by trowel onto the side end of the panel. Place the panel gently onto the previous panel. Remove excess by trowel.
  • For gap filling
    Filling the Crocodile Wall Joint Mortar by trowel onto the joint or gap. Smooth the surface. Damp the surface by water to avoid micro crack.


Estimated Coverage
1 bag (20 kg) of Crocodile Wall Joint Mortar can laying panel approximately 7-9 sq.m. Depends on type of material and condition of the substrate. The exact consumption must be determined by means of a sampling of the work.

Tools
Trowel

How to clean the tools
Clean tools after use with clean water.

Suggestion

  • Damp the surface by water before apply adhesive mortar, to reduce water absorption of material cause cracking problem.
  • Any sand, dust or small gravel on the substrate must be removed from the surface before apply.
  • Do not use product on hot surface or contact to direct sunlight. Substrate needs to reduce the temperature by water before apply the products


Caution

  • Recommend to use rubber gloves, dust protection masks, eye safety goggles and personal safety equipment.
  • Apply in good ventilation area. Do not inhale products.
  • In case of any spill on eyes, rinse immediately with clean water and seek medical advice.
  • Keep away from children.

Download