MortarSuper Premium

MortarSuper Premium is a superfine natural mortar with graphene technology. It is applied as a final finishing coat for high-decoration finishes such as ironing, texturised, combed, etc. Ideal for plastering in building, rehabilitation and restoration of listed properties.

Application Instructions

Substrate Preparation
The substrate must be dry, firm, well adhered, free of any impurity and must have a grip to ensure the adhesion of the product.

Product preparation
Pour off the water from Kalgraphin Premium pack and keep it to remix the content. Use the remaining contents of the Kalgraphin Premium. Mix the contents of Mortar Super with the remaining contents of the Kalgraphin Premium depending on the desired consistency. Re-add the water from the Kalgraphin Premium pack never more than 1 l. Mix with mechanical mixer until its total homogenization and adequate consistency. Leave 20-30 minutes. Re stir 1 minutes more before applying.

Application method
Apply a first level coat and then apply a second one evenly until achieving the desired thickness (work thickness: 1-5 mm per day). At the start of drying, finish according to the desired finish. If there are supports of different nature, meshes must be used.

Drying
In conditions of 25ºC and 60% relative humidity: 24-48 hours between layers of mortar. The carbonation process mainly occurs during the first 30 days.

Environmental conditions
The work temperature (environment and support) must be greater than +5ºC and less than +30ºC. Do not apply in direct sunlight, strong winds, rain, freezing or on supports heated by the sun.

Coverage
Approximate 3.5 kg/m2 for 1-2 mm It depends on the type and condition of the substrate. The exact consumption must be determined by the means of a sampling of the work.

Tools
Mechanical agitator, trowel, notched trowel or similar, sponge trowel.

Tool cleaning
Clean tools after use with warm water

Additional Information

• Do not drench the substrate before application, only lightly moisten if very dry.
• Careful not to add too much water into the mix.
• Do not water for hardening, it hardens by absorbing atmospheric CO2.
• Do not apply to surfaces in constant contact with water.
• It is recommended to protect the treated surface from rain for at least 4 days.

Caution

• None in particular for normal use and people who do not have special pathologies.
• Alkaline product, protect skin and eyes especially.
• Apply with good ventilation, do not inhale product.
• Keep out of reach of children.

Storage
Keep in original pack. It should be kept in a dry place and avoid direct sun exposure. Unopened, it may be conserved for at least 36 months from the date of manufacture. After mixing keep the remaining mortar by water casting 1 inches high and seal in a bucket to avoid hardening. (check it every 3 months)